Rockwell Automation SP200 AC Drive Remote Keypad M/N S20-RK1 - Manual (Page 20)

2-2 SP200 AC Drive Remote Keypad
English
Step 1. Refer to figure 2.2. Remove the backing from the
gasket.
Step 1. Align the keypad with the drilled holes in the door
and install the keypad to the enclosure.
Step 1. Fasten the keypad to the enclosure using the six
M6-32 KEPS screws. Tighten the screws in the
sequence indicated in figure 2.2.
Temporarily torque all screws to 0.3 Nm (2.7 in lb),
then re-torque to 0.6 Nm (6.0 in lb). This ensures a
good seal between the gasket and the enclosure.
Figure 2.1 – Remote Keypad Mounting Template
3.94
140
5.51] [
70
2.76] [
7,5
0.30] [
135
5.32] [
90
3.54] [
5
0.20] [
ø4,5
0.18] [
[100]
dimensions = mm [in]