Configure an ethernet/ip communication module, What you need, Equipment setup – Rockwell Automation 2706-P_P InView Quick Start User Manual
Page 10

Publication 2706-QS001D-EN-P - January 2009
10 InView Marquee Message Display
Configure an EtherNet/IP
Communication Module
Follow these steps to configure an EtherNet/IP communication
module.
What You Need
This list indicates what you need to complete this task:
•
Catalog numbers 2706-P22R, 2706-P4x, 2706-P7x, 2706-P9x
•
Catalog numbers 2706-PENETP, 2706-PENETM, 2706-PENETK
InView Ethernet modules
•
Ethernet cable (user supplied)
•
RS-232 serial cable (supplied with Ethernet module)
•
RSLinx software
•
InView User Manual, publication
•
InView Installation Instructions, publication
•
Communication Module Installation Instructions, publication
•
Communication Module User Manual, publicatio
Equipment Setup
Follow these instructions to configure the communication module for
a 2706-P22R display.
•
Connect a Class 2, 24V DC power supply.
•
Connect the RS-232 (catalog number 2711-NC13) cable to a
personal computer.
TIP
Use a 2706-PENETP module for a 2706-P22R display, a 2706-PENETM
module for a 2706-P4x display, and a 2706-PENETK module for a
2706-P7x or 2706-P9x display.
1
2
3
4
5
6
7
8
9
RS-232
2711-NC13 Cable
Supplied
Network
Communication
Power
Power