Remove the drive covers – Rockwell Automation 2099-K7KCB-1 Kinetix 7000 DC-DC Converter and Control Board Kits User Manual
Page 4
Publication 2099-IN002B-EN-P — October 2008
4
Kinetix 7000 DC-DC Converter and Control Board Kits
2.
Allow five minutes for the dc bus to completely discharge before
proceeding.
3.
Label and remove the fiber-optic (Tx and Rx) cables, and I/O (IOD),
motor feedback (MF), and auxiliary feedback (AF) connectors from the
drive.
4.
Go to Remove the Drive Covers.
Remove the Drive Covers
Depending on the catalog number of your Kinetix 7000 drive, access to the
control board, dc-dc converter, and fuse varies.
ATTENTION
This product contains stored energy devices. To avoid
hazard of electrical shock, verify that all voltage on
capacitors has been discharged before attempting to
service, repair, or remove this unit. You should only attempt
the procedures in this document if you are qualified to do
so and are familiar with solid-state control equipment and
the safety procedures in publicatio.
ATTENTION
This drive contains ESD (electrostatic discharge) sensitive parts
and assemblies. You are required to follow static control
precautions when you install, test, service, or repair this
assembly. If you do not follow ESD control procedures,
components can be damaged. If you are not familiar with static
control procedures, refer to Guarding Against Electrostatic
Damage Service Bulletin,
r any other
applicable ESD protection handbook.
Cat. No.
Topic
Page
2099-BM06-S, 2099-BM07-S, or
2099-BM08-S
Remove 2099-BM06-S, 2099-BM07-S,
and 2099-BM08-S Covers
2099-BM09 -S or 2099-BM10-S
Remove 2099-BM09-S and 2099-BM10-S
Covers
2099-BM11-S, or 2099-BM12-S