Rockwell Automation 8510 AC Spindle Drive System Programming Manual - Manual (Page 17)

Programming
Chapter 2
2-14
MOTOR SELECT Menu This menu (Figure 2.4) selects the motor that will be used with this drive.
Figure 2.4
MOTOR SELECT Menu Tree
MOTOR SELECT
Catalog Num
Catalog Num
This parameter lists the available spindle motors. Simply select the catalog
number of the motor being used. If a motor was previously selected, that
number will be displayed. If a motor was not previously selected, the
display will show “NONE SELECTED.”
Important: The default parameters do not include the motor type. This
parameter must be programmed before attempting to enable the drive or a
fault will occur.
Data Format: 1327AB-AFL-15
Default Value: NONE SELECTED
PARAMETER SET Menu The PARAMETER SET menu allows the selection and programming of
basic drive configuration parameters and preset parameters.
Figure 2.5
PARAMETER SET Menu Tree
PARAMETER SET
ELECT CONFIG
SPINDL PRESET SPINDL PRESET
Acc Rate #1
Acc Rate #2
Low Torq Lmt
At–Set–Speed
Speed Detect
Load Detect
Overspd Trip
ELECT CONFIG
Cmnd Phase #1
Cmnd Phase #2
Motor Phasing
Enable Torque
Drive Cat Num