Rockwell Automation 2080-LC30-48AWB_48QWB_48QVB_48QBB Micro830 48 Point LC30 Programmable Controllers - Manual (Page 9)

Micro830 48 Point Programmable Controllers 9
Publication 2080-IN005B-EN-P - April 2014
1. Hook the top of the DIN rail mounting area of the controller onto the DIN rail, and
then press the bottom until the controller snaps onto the DIN rail.
2. Push the DIN rail latch back into the latched position.
Use DIN rail end anchors (Allen-Bradley part number 1492-EA35 or 1492-EAHJ35)
for vibration or shock environments.
To remove your controller from the DIN rail, pry the DIN rail latch downwards until it is in the
unlatched position.
Panel Mounting
The preferred mounting method is to use four M4 (#8) screws per module. Hole spacing
tolerance: ±0.4 mm (0.016 in.).
Follow these steps to install your controller using mounting screws.
1. Place the controller against the panel where you are mounting it. Make sure the
controller is spaced properly.
2. Mark drilling holes through the mounting screw holes and mounting feet then remove
the controller.
3. Drill the holes at the markings, then replace the controller and mount it.
Leave the protective debris strip in place until you are finished wiring the controller and
any other devices.
Panel Mounting Dimensions
45327
100 mm
(3.9 in.)
108 mm (4.25 in.) 108 mm (4.25 in.)