Additional resources – Rockwell Automation 2080-LC30-48AWB_48QWB_48QVB_48QBB Micro830 48 Point LC30 Programmable Controllers User Manual
Page 6
6 Micro830 48 Point Programmable Controllers
Publication 2080-IN005B-EN-P - April 2014
Additional Resources
If you would like a manual, you can:
• download a free electronic version from the Internet:
• purchase a printed manual by contacting your local Allen-Bradley distributor or
Rockwell Automation representative
ATTENTION:
•
To comply with the CE Low Voltage Directive (LVD), this equipment must be
powered from a source compliant with the following: Safety Extra Low Voltage
(SELV) or Protected Extra Low Voltage (PELV).
•
To comply with UL restrictions, this equipment must be powered from a Class 2
or Limited Voltage Limited Current Source (LVLC).
ATTENTION:
•
Electrostatic discharge can damage semiconductor devices inside the module.
Do not touch the connector pins or other sensitive areas.
•
Do not remove the protective debris strips until after the controller and all other
equipment in the panel near the module are mounted and wired. Remove strips
before operating the controller. Failure to remove strips before operating can
cause overheating.
•
Be careful when stripping wires. Wire fragments that fall into the controller
could cause damage. Once wiring is complete, make sure the controller is free
of all metal fragments.
Resource
Description
Micro830
®
and Micro850
®
Programmable
Controllers User Manual,
publication
A more detailed description of how to install and use your
Micro830 and Micro850 programmable controllers.
Micro800
®
AC Power Supply Installation
Instructions, publication
Information on wiring and installing the optional AC power supply.
Micro800 Plug-in Modules User Manual,
publication
Installation and wiring descriptions for the different Micro800
plug-in modules.
Industrial Automation Wiring and
Grounding Guidelines, publication
More information on proper wiring and grounding techniques.