Rockwell Automation 9329 Drive Application Software - Manual (Page 2)

FM – Inertia Compensation
Application Software – page 2 of 30
Important User Information
Users of this Reference Manual must be familiar with the application this Function Module is
intended to support and its usage. Function Modules intended usage are as a building blocks for
a created application. The user must be familiar with the programming tools used to implement
this module, the program platform to be used in the application, and the Rockwell Automation
drive products to be controlled in the application.
Because of the variety of uses for the products described in this publication, those responsible for
the application and use of this control equipment must satisfy themselves that all necessary steps
have been taken to assure that each application and use meets all performance and safety
requirements, including any applicable laws, regulations, codes and standards.
The illustrations, charts, sample programs and layout examples shown in this guide are intended
solely for purposes of example. Since there are many variables and requirements associated with
any particular installation, Rockwell Automation does not assume responsibility or liability (to
include intellectual property liability) for actual use based upon the examples shown in this
publication.
Rockwell Automation publication SGI-1.1, Safety Guidelines for the Application, Installation, and
Maintenance of Solid-State Control (available from your local Rockwell Automation office),
describes some important differences between solid-state equipment and electromechanical
devices that should be taken into consideration when applying products such as those described
in this publication.
Reproduction of the contents of this copyrighted publication, in whole or in part, without written
permission of Rockwell Automation, is prohibited.
Trademarks
RSLogix5000 is a trademark of Rockwell Automation
PowerFlex is a trademark of Rockwell Automation