Rockwell Automation 2085-IQ16_IQ32T 24V DC 16 and 32 Sink/Source Input Modules - Manual (Page 12)

12 Micro800 16-point and 32-point 12/24V Sink/Source Input Modules
Publication 2085-IN001A-EN-P - September 2012
6. Insert the assembled wire contact into the terminal socket. Push the wire contact in until
the tang latches. Make sure the tang is properly latched by lightly pulling on the wire.
Specifications
General Specifications
Attribute 2085-IQ16 2085-IQ32T
Number of Inputs 16 32
Dimensions
HxWxD 44.5 x 90 x 87 mm
(1.75 x 3.54 x 3.42 in.)
Shipping weight, approx. 220 g (7.76 oz)
Bus current draw, max 170 mA @ 5V DC 190 mA @ 5V DC
Wire size 0.25... 2.5 mm 2 (22...14 AWG) solid or stranded copper wire rated at 75 °C (167 °F ), or greater,
1.2 mm (3/64 in.) insulation max
Wiring category (1)
(1) Use this Conductor Category information for planning conductor routing. Refer to Industrial Automation Wiring and Grounding Guidelines,
publication
1770-4.1 .
2 – on signal ports
Terminal screw torque,
max 0.5…0.6 Nm
(4.4…5.3 lb-in.)
(2)
(2) RTB hold down screws should be tightened by hand. They should not be tightened using a power tool.
Input circuit type 24V AC/DC sink/source
Power dissipation, total 4.5 W 7 W
Power supply 24V DC
Status indicators 16 yellow indicators 32 yellow indicators
Isolation voltage 50V (continuous), Reinforced Insulation Type, channel to system
Type tested at 720V DC for 60 s
Enclosure type rating None (open-style)
North American temp code T4
44922
Terminal connector
Terminal sockets
Wire contact