Rockwell Automation 57C610 Enhanced Basic Language, AutoMax - Manual (Page 143)

FĆ1
Appendix F
New Features
The following are either new or changed in BASIC for Version 3.0 of the
AutoMax Programming Executive.
1. ENI_INIT%
2. SOCKET%
3. BIND%
4. CONNECT%
5. ACCEPT%
6. SEND%
7. SENDL%
8. RECV%
9. RECVL%
10 SETSOCKOPT%
11. GETSOCKOPT%
12. SHUTDOWN%
13. READVAR%
14. WRITEVAR%
15. FINDVAR!
16. CONVERT%
The following are either new or changed in BASIC for Version 3.3 of the
AutoMax Programming Executive.
Section 2.3 Ć
describes the use of BASIC statements and functions in UDC
Control Block tasks.
Appendix D Ć lists the BASIC functions and statements supported in UDC
Control Block tasks.
Appendix E Ć lists the AutoMax Processors that are compatible with
versions of the AutoMax Programming Executive software.
The following are either new or changed in BASIC for Version 3.4 of the
AutoMax Programming Executive.
Section 4.1.1 has been revised to state that E" notation should be used to
indicate an exponent in BASIC.
Section 8.0, describing the Ethernet functions, now states that tasks that use the
Ethernet functions must be run on the leftĆmost Processor in the rack.
The following functions have been added to BASIC:
RTS_CONTROL@
ALL_SENT@
WRITE_TUNE
Additional BASIC statements and functions that can now be used in UDC tasks:
FORĆNEXT
SET_MAGNITUDE
SIN, COS, TAN, ATAN
EXP
LN
BCD_IN%, BCD_OUT%
WRITE_TUNE