Rockwell Automation 57C610 Enhanced Basic Language, AutoMax - Manual (Page 10)

1Ć2
1.2 Additional Information
You should be familiar with the instruction manuals which describe
your system configuration. This may include, but is not limited to,
the following:
D JĆ3618 NORTON EDITOR REFERENCE MANUAL
D JĆ3649 AutoMax CONFIGURATION TASK INSTRUCTION
MANUAL
D JĆ3650 AutoMax PROCESSOR INSTRUCTION MANUAL
D JĆ3676 AutoMax CONTROL BLOCK LANGUAGE
INSTRUCTION MANUAL
D JĆ3677 AutoMax LADDER LOGIC INSTRUCTION MANUAL
D J2Ć3018 AutoMax Remote I/O Shark Interface Instruction
Manual
D J2Ć3093 AutoMax Ladder Language Editor
D J2Ć3094 AutoMax Enhanced Ladder Language
D Your ReSource AutoMax PROGRAMMING EXECUTIVE
INSTRUCTION MANUAL
D Your personal computer, DOS, and Windows instruction manuals
D IEEE 518 GUIDE FOR THE INSTALLATION OF ELECTRICAL
EQUIPMENT TO MINIMIZE ELECTRICAL NOISE INPUTS TO
CONTROLLERS
1.3 Related Hardware and Software
The AutoMax Programming Executive software is used with the
following hardware and software, which is sold separately.
1. M/N 57C430A, M/N 57C431, or M/N 57C435 AutoMax
Processor.
2. IBMĆcompatible 80386Ćbased personal computer running DOS
Version 3.1 or later. Version 4.0 and later Executive software
requires an 80486Ćbased personal computer (or higher) running
Windows 95.
3. M/N 61C127 RSĆ232C ReSource Interface Cable. This cable is
used to connect the personal computer to the Processor
module.
4. M/N 57C404A (and later) Network Communications module.
This module is used to connect racks together as a network and
supports communication with all racks on the network that
contain 57C404A modules through a single Processor module.
M/N 57C404 can be used to connect racks on a network;
however, you cannot communicate over the network to the
racks that contain M/N 57C404 Network modules. You must
instead connect directly to the Processors in those racks.
5. M/N 57C440 Ethernet Network Interface module. This module is
used to connect AutoMate Processors to TCP/IP Ethernet local
area networks.