Rockwell Automation 2711P-RBxxx Display Module Bezel Replacement Installation Instructions - Manual (Page 6)

6 Display Module Bezel Replacement
Publication 2711P-IN018C-MU-P - March 2007
8. Detach all connectors, maximum of 3.
The number of connectors varies by model.
• IrDa connector, if present
• Function key connector
• Touch screen connector
9. Set the bezel aside.
Replace the Display Module Bezel
1. Make sure the new bezel is free of lint and marks before attaching.
2. Attach the connectors
The number of connectors varies by model.
• IrDa connector, if present
• Function key connector
• Touch screen connector
3. Place the back of the display module over the new bezel.
Be careful not to pinch any of the cables. Allow the touch screen connector
to extend out of the access opening.
4. Attach the touch screen connector.
5. Replace the sealing gasket.
6. Attach the screws that secure the display module to the bezel and tighten to
a torque of 1.35…1.58 Nm (12…14 lb-in).
7. On touch screen terminals, reattach the small metal plate to the back of the
display module using two screws and torque to 0.68Nm (6…8 lb-in).