Rockwell Automation 2711P-RBxxx Display Module Bezel Replacement Installation Instructions - Manual (Page 4)

4 Display Module Bezel Replacement
Publication 2711P-IN018C-MU-P - March 2007
Precautions
Before installing or replacing any components, disconnect power from the terminal.
During installation, take care not to touch any of the exposed electronic
components.
Remove the Display Module Bezel
It is not necessary to remove the logic module or communication module before
removing the bezel, except for the PanelView Plus 700 or PanelView Plus CE 700.
1. Disconnect power from the terminal.
2. Set the terminal, display side down, on a flat stable surface.
3. On touch screen terminals, remove the two screws that secure the small
metal plate to the back of the display module.
ATTENTION
Disconnect all power from the terminal before installing or replacing any components.
Failure to disconnect power may result in electrical shock or damage to the terminal.
ATTENTION
Work in a static free environment and wear a properly grounded electrostatic discharge
(ESD) wristband. Be careful when touching any of the exposed electronic components to
prevent damage from ESD.
IMPORTANT
Wear a properly ground ESD wristband before touching any of the electronic
components in the logic module.
Plate
Touch Screen Connector