Rockwell Automation 2094-BSP2 Kinetix 6000 Shunt Module Installation Instructions - Manual (Page 6)

6 Kinetix 6000 Shunt Module
Publication 2094-IN004E-EN-P — June 2008
4. Pivot module downward and align the guide pins on the power rail with the
guide pin holes in the back of the module.
5. Gently push the module against the power rail connectors and into the final
mounting position.
6. Use 2.26 N•m (20 lb•in) torque to tighten the mounting screw.
Guide Pin
Holes
Power rail (side view)
in upright vertical position.
IAM, AM, Shunt, or
Slot-filler Module, Side View
(IAM module is shown)
Guide Pins
Pivot module downward
and align with guide pins.
IAM, AM, Shunt, or
Slot-filler Module, Rear View
(IAM module is shown)
Power Rail
Bracket secured
in slot.
IAM, AM, Shunt, or
Slot-filler Module
(IAM module is shown)
Mounting Screw
Bottom front view of
shunt module.