Rockwell Automation 1799ER-IQ10XOQ10 Dual-Port EtherNet Embedded I/O Board with 10 Inputs/ Outputs - Manual (Page 16)

16 Dual-Port EtherNet Embedded I/O Board with 10 Inputs/ 10 Outputs
Publication 1799ER-IN001B-EN-P - May 2013
Specifications
5 Group 0 Input OFF_ON Delay Filter (High Byte)
6 Group 0 Input ON_OFF Delay Filter (Low Byte)
7 Group 0 Input ON_OFF Delay Filter (High Byte)
8 Reserved IV_G0 IA_G0 FV_G0 FA_G0
9 Reserved (pad)
CRN = Configuration Revision Number. Value is 0 after power-on reset and after completely closing the
connection. Value is 1 when the module is configured. Once a module is configured, the only way to
change its configuration is to close the connections to it or use the override value of 0.
FA_Gx = Fault Action Group x. 0 = Apply Fault Value, 1 = Hold Last State
IA_Gx = Idle Action Group x. 0 = Apply Idle Value, 1 = Hold Last State
FV_Gx = Fault Value Group x. 0= Off, 1=On
IV_Gx = Idle Value Group x. 0= Off, 1=On
Input Filter values = 0, 1000, 2000, 4000, 8000, or 16000 microseconds.
Input
Attribute Value
Inputs per block 10 sinking or sourcing, Type 1 + compatible
Off-state voltage 5V DC max
Off-state current 1.5 mA max
On-state voltage 10...30V DC
On-state current 2...11 mA
Output
Attribute Value
Outputs per block 10 sinking or sourcing, 0.5A, short circuit protected, pilot duty
Output auxiliary voltage 10...30V DC
On-state voltage drop 250 mV max
Instance 102 - Configuration Input / Output
Config Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0