Rockwell Automation 2706-PxM_PxK_PxP InView Communication Module Installation User Manual

Page 4

4 InView Communication Modules

Publication 2706-IN015E-EN-P - May 2007

1. Disconnect power to the InView display.

2. Remove the six screws from the power supply cover and remove cover.

Set the screws and cover aside for a later step.

3. Feed the serial cable through the cable grip (shipped with module).

4. Insert the serial wires through the conduit opening on either the top or the

bottom of the InView display.

5. Mount the cable grip to the InView display housing, tighten the locknut

finger-tight, and rotate an additional 1/2 turn.

ATTENTION

Hazardous voltage. Contact with high voltage may cause death or serious
injury. Always disconnect power to the InView display prior to servicing.

2706-P42 and 2706-P44

Cover Screws

Power Line

Insert the serial wires with
the cable grip into one of
these conduit openings.

TB1 Terminal Block for Serial Connection