Rockwell Automation 2706-PxM_PxK_PxP InView Communication Module Installation - Manual (Page 3)

InView Communication Modules 3
Publication 2706-IN015E-EN-P - May 2007
Power Supply Requirements
• The 2706-PxM and 2706-PxK modules are powered by the InView 2706-P4x,
2706-P7x, and 2706-P9x displays.
• The 2706-PxP module requires an external 24V ±25%, 1 A dc power supply
for use with the InView 2706-P22R panel mount display.
Mount the Communication Module to the 2706-P42 and 2706-P44
Displays
The InView communication module, catalog number 2706-PxM, is designed to
mount to the track of the InView 2706-P42 and 2706-P44 displays. The back plate of
the module has tabs for attaching to the track. Tighten mounting screws until they
bottom out against the back plate.
Wire the Communication Module to the 2706-P42 and 2706-P44 Displays
Below is an illustration and description of the InView communication module and
its connectors with relation to an InView 2706-P4x display.
For ease in mounting, rotate
module 90° so that the
mounting holes are on top and
bottom. Rotate the module
clockwise over track until the
alignment is horizontal.
TB1
To TB1
To Controller
(user-supplied
cable)
NEMA Type 12 enclosure with removable cover.
Torque enclosure cover screws to 0.68 Nm (6 lb-in).
User-supplied cable
routed through
NEMA-rated cable
grip (supplied).
Back of InView Display (2706-P42 and 2706-P44)
Serial cable to be connected
to terminal block inside
power supply cover on back
of InView display. Cable to
be routed through cable grip
(supplied).
2706-PxM