Rockwell Automation 57C402 25-115V AC/DC Low Power Output Module - Manual (Page 11)

3Ć1
3.0 INSTALLATION
This section describes how to install and remove the module and its
cable assembly.
3.1 Wiring
The installation of wiringshould conform to all applicable codes.
To reduce the possibility of electrical noise interferingwith the proper
operation of the control system, exercise care when installingthe
wiringfrom the system to the external devices. For detailed
recommendations refer to IEEE 518.
3.2 Initial Installation
Use the followingprocedure to install the module:
Step 1.
Turn off power to the system. All power to the rack as well
as all power to the wiringleadingto the module should be
off.
Step 2. Mount the terminal strip (M/N 57C370) on a panel. The
terminal strip should be mounted to permit easy access to
the screw terminals on the terminal strip. Make certain that
the terminal strip is close enough to the rack so that the
cable will reach between the terminal strip and the
module.
Step 3. Fasten field wires to the terminal strip. Note that the bit
number and wire number are not the same. Refer to
Appendix C for the arrangement of terminal strip
connections. Make certain that all field wires are securely
fastened. Typical field signal connections are shown in
figure 3.1.