Rockwell Automation 2755 High Performance VLD Scanner - Manual (Page 36)

4–5 Installing the Scanner
Use the steps below as a guideline when connecting equipment.
Refer to the User Manual for your decoder when necessary.
1. Verify that the power to the decoder is TURNED OFF.
2. Connect optional package detector to the package detector cable
on back of scanner. See next section.
3. Connect the scanner to the decoder by attaching the scanner cable
(with the connected extension cable if appropriate) to the scanner
port on the back of the decoder.
4. Set up decoder.
•
Connect the configuration terminal to the AUX port of the
decoder.
•
Configure the decoder for your application if you have not
already done so. Refer to Decoder User Manual.
5. Refer to Chapter 5 on scanner operation.
Connecting Equipment