Rockwell Automation 1757-FFLDC4 ControlNet Foundation Fieldbus Linking Device Installation Instructions User Manual
Page 20
20 ControlNet Foundation Fieldbus Linking Device
Publication
1757-IN022B-EN-P - August 2009
Reset to Factory Default
The factory-default reset sets the linking device’s Ethernet network
configuration to use the static IP address of 192.168.1.10, resets the web page
user name and password, resets all services (for example, web services), and
clears all downloaded fieldbus configuration. To complete a factory-default
reset, complete the steps below.
1. Verify that the linking device is powered up and in a running state
(H1 status indicators are blinking).
2. Press the reset button.
WARNING
When you press the reset button while power is on, an electrical arc can occur.
This could cause an explosion in hazardous location installations.
Be sure the area is nonhazardous before proceeding.