Rockwell Automation 1746-HSCE High-Speed Counter Module Installation Instructions - Manual (Page 13)

High-Speed Counter Module 13
Publication 1746-IN011C-EN-P - April 2005
Input and Output Connections
Input and output wiring terminals are located on the front of the module, behind
the terminal cover. When you connect input and output devices, you must also be
concerned with the settings of dip switch SW1 (input connections), dip switch SW2
(output connections), and jumper JW1 (limit switch input connections). The
location and description of these are shown on pages 6 through 9.
1
2
3
4
5
6
7
0 A
B
Z
LS
FAULT
VDC
HSCE
OUT 1
OUT 3
OUT 0
OUT 2
A+
A-
Not
Used Not
Used
Z+
Z-
LS
COM
DC
COM
B+
B-
LS
(24V dc)
LS
(12V dc)
LS
(5V dc)
VDC
OUT 0
OUT 1
OUT 2
OUT 3
DC COM
A+
B+
A-
B-
Not used
Not used
Z+
LS (24 VDC )
Z-
LS (12 VDC )
LS COM
LS (5 VDC )
OUTPUT INPUT
Upper Retaining Screw Maximum
Torque = 0.7 to 0.9 Nm (6 to 8 in-lbs)
Lower Retaining Screw Maximum
Torque = 0.7 to 0.9 Nm (6 to 8 in-lbs)
Discrete Output Wiring
NOTE: V dc must be externally
supplied by the user. See
page 14 for output wiring.
Terminal Wiring
max. 2 wires per terminal
max. torque: 0.9 Nm (8 in-lbs)
Limit Switch and
Encoder Input Wiring
See pages 15 through 19 for
input wiring.