Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module Installation Instructions - Manual (Page 10)

10
Publication 1756-IN571B-EN-P - April 2001
Set the Module’s Network Address Switches
Use your fingers or a small screwdriver to set the module’s network
address switches. For modules in a standalone chassis, you must
specify a unique ControlNet network address; for modules in a
redundant chassis, you must specify the same address for the
secondary module that you specified for the corresponding primary
module. You can select an address of 01 to 99 for modules in a
standalone chassis or 01 to 98 for modules in redundant chassis. Note
that OO is an invalid ControlNet address.
side of module
fr
ont
of
module
top of module
This module’s network
address is 23.