Rockwell Automation 1762-Lxxxxx MicroLogix 1200 Programmable Controllers Installation Instructions - Manual (Page 10)

10 MicroLogix 1200 Programmable Controllers
Publication 1762-IN006C-EN-P - September 2009
Mounting the Controller
General Considerations
Most applications require installation in an industrial enclosure to reduce the effects of
electrical interference and environmental exposure. Locate your controller as far as possible
from power lines, load lines, and other sources of electrical noise such as hard-contact
switches, relays, and AC motor drives. For more information on proper grounding guidelines,
see the Industrial Automation Wiring and Grounding Guidelines publication 1770-4.1.
Classification des environnements Câbles de communication
Environnement dangereux de Classe I, Division 2 1761-CBL-PM02 série C ou ultérieure
1761-CBL-HM02 série C ou ultérieure
1761-CBL-AM00 série C ou ultérieure
1761-CBL-AP00 série C ou ultérieure
707-NC8 série B ou ultérieure
2707-NC10 série B ou ultérieure
2707-NC11 série B ou ultérieure
ATTENTION
Vertical mounting is not recommended due to thermal
considerations.
ATTENTION
Be careful of metal chips when drilling mounting holes for
your controller or other equipment within the enclosure or
panel. Drilled fragments that fall into the controller could
cause damage. Do not drill holes above a mounted controller
if the protective debris strips have been removed.