Rockwell Automation 1792D-8BT8LP ArmorBlock LP2 8 Sinking Input/8 Output Modul - Manual (Page 4)

4 ArmorBlock LP2 8 Sinking Input/ 8 Output Module
Publication 1792D-5.42 - July 1999
Connect the Input/Output Cord Sets to the LP2 Module
This module uses 5 pin micro (12mm) style PCB mounted connectors.
Eight micro caps cover the connectors on your module. Remove the caps
and connect your cord sets to the appropriate ports. This product has two
input or outputs per I/O connector. Use a “Y” splitter cable for access to all
I/O connections. For more information on these cables, see the Product
Data guide, publication 1792-2.1.
Use the micro caps to cover and seal unused ports. A pinout diagram for
the connectors is shown below.
1
5
3 4
2
41452
Input Micro-Connector
(View into Sockets)
Pin 1 Sensor Source Voltage
Pin 2 Input B
Pin 3 Return Logic Ground 1
Pin 4 Input A
Pin 5 Not Used
1.
Logic Ground is approximately 0.4V above DeviceNet V-measured at the module.
1
5
3 4
2
Output Micro-Connector
(View into Sockets)
Pin 1 Not Used
Pin 2 Output B
Pin 3 Auxiliary Power Ground
Pin 4 Output A
Pin 5 Not Used