Rockwell Automation 1792D-8BT8LP ArmorBlock LP2 8 Sinking Input/8 Output Modul - Manual (Page 3)

ArmorBlock LP2 8 Sinking Input/ 8 Output Module 3
Publication 1792D-5.42 - July 1999
Install Your ArmorBlock LP2 I/O Module
To install the module you must:
• Set the node address and baud rate.
• Mount the module.
• Connect the input/output cord sets to the LP2 module.
• Communicate with your ArmorBlock LP2 I/O module.
Each of these steps is discussed in detail in the following procedures.
Set the Node Address and Baud Rate
Set the node address using RSNetWorx for DeviceNet™ software,
DeviceNetManager™ software, or another software configuration tool.
The module is equipped with AutoBaud detect. AutoBaud lets the module
read the settings already in use on your DeviceNet network and
automatically adjusts to follow those settings.
Mount the Module
1. Attach the module using the dimensions shown below.
2. Connect the grey DeviceNet cable to the DeviceNet trunk. Use the
1485P-P1R5-MN5R1 T-Port tap to connect to round media. Use the
1485P-P1E4-R5 to connect to the Kwik Link flat media system.
I-4
I-5
I-6
I-7
O-4
O-5
I-2
I-3
O-2
O-3
O-6
O-7
Network Status Module Status
I-0
I-1
O-0
O-1
Auxiliary Power
4.21 in
107mm
41953
1.02 in
26.0mm
1.95 in
49.5mm
12 in
305mm
0.25 in
6.25mm