Rockwell Automation 1771-P3_P4_P5_P5E Power Supply Modules Installation Instructions - Manual

Publication 1771ĆIN073A-EN-P - March 2002
Power Supply Modules
Cat. No. 1771–P3, –P4, –P5 and –P5E
Use this document as a guide when installing the catalog number
1771-P3, -P4, -P5 or -P5E power supplies.
To See page
Important User Information 1
Preinstallation Considerations 5
ConnectingInput Power 7
Settingthe Power Loss Time Delay (1771ĆP5E only) 8
Installingthe Power Supply 9
MakingInput Power Connections 10
ParallelingPower Supplies 12
For this reference information See page
Status Indicators 13
Troubleshooting 14
Safety Approvals 17
Specifications 18
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of these
products must satisfy themselves that all necessary steps have been
taken to assure that each application and use meets all performance
and safety requirements, including any applicable laws, regulations,
codes and standards. In no event will Allen–Bradley be responsible
or liable for indirect or consequential damage resulting from the use
or application of these products.
Any illustrations, charts, sample programs, and layout examples
shown in this publication are intended solely for purposes of
example. Since there are many variables and requirements associated
with any particular installation, Allen–Bradley does not assume
responsibility or liability (to include intellectual property liability)
for actual use based upon the examples shown in this publication.
Allen–Bradley publication SGI–1.1, Safety Guidelines for
Application, Installation, and Maintenance of Solid–State Control
(available from your local Allen–Bradley office), describes some
important differences between solid–state equipment and
electromechanical devices that should be taken into consideration
when applying products such as those described in this publication.
Installation Instructions
Contents
Important User
Information