Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device - Manual (Page 31)

Ethernet-to-DeviceNet Linking Device 31
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
3. From the Revision pull-down menu, choose the controller version.
4. Enter a name for the controller project.
5. Click OK.
A project is created.
6. In the left pane, right-click I/O Configuration.
7. Click New Module.
8. In the Select Module Type menu, choose any EtherNet/IP Bridge
Module (such as the 1788-ENBT module).
9. Click OK.
You see the Module Properties dialog box.
10. In the Slot Number field, enter the slot number in which the device
resides.
11. Click Finish.
12. In the right pane, right-click the EtherNet/IP module you just added to
your project.
13. Click New Module.