Rockwell Automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device User Manual
Ethernet-to-devicenet linking device, Installation instructions
Installation Instructions
Ethernet-to-DeviceNet Linking Device
Catalog Number 1788-EN2DN
This publication tells you how to install the 1788-EN2DN
Ethernet-to-DeviceNet linking device and use RSNetWorx™ for DeviceNet
software to configure it.
Topic
Page
Installing and Configuring the Linking Device
Table of contents
Document Outline
- 1788-IN055C-EN-P, Ethernet-to-DeviceNet Linking Device Installation Instructions
- Important User Information
- North American Hazardous Location Approval
- European Hazardous Location Approval
- Environment and Enclosure
- About the Linking Device
- System Requirements
- Installing and Configuring the Linking Device
- Connect the Linking Device to the EtherNet/IP Network
- Connect the Linking Device to the DeviceNet Network
- Configure the Linking Device IP Address
- Register the Driver in RSLinx Software
- (Optional) Register the EDS file in RSNetWorx Software
- Use RSNetWorx for DeviceNet Software to Locate the Module on the Network
- Set the DeviceNet MAC ID and Communication Rate
- (Optional) Disable Autobaud
- (Optional) Configure DeviceNet I/O
- (Optional) Add the Linking Device to an RSLogix 5000 Software Project
- Understanding Status Indicators
- I/O Status Indicator
- DeviceNet Network Status Indicator
- Module Status Indicator
- Ethernet Link Status Indicator
- Ethernet Network Status Indicators
- CIP Link Status Indicator
- Using Diagnostic Web Pages
- Dimensions
- DeviceNet Connector Pinouts
- EtherNet/IP RJ45 Connector Pinouts
- Specifications
- Additional Resources
- Back Cover