Rockwell Automation 1747-PCINT API Software for 1746 I/O User Manual
Page 33
Developing Applications
3–7
Publication 1747-6.5.3 Junel 1998
/*
** Open the scanner
*/
retcode = OC_OpenScanner( &Handle, 0, 0);
if ( retcode != SUCCESS )
{
printf( ”\nERROR: OC_OpenScanner failed: %d\n”, retcode );
Ioexit( 1 );
}
/*
** Reset the scanner
*/
printf( ”\n\n Going to reset OC, takes 6 seconds to complete...\n” );
retcode = OC_ResetScanner( Handle, OCWAIT );
if ( retcode != SUCCESS )
{
printf( ”\nERROR: OC_ResetScanner failed: %d\n”, retcode );
Ioexit( 1 );
}
/*
** Check scanner status register
*/
retcode = OC_GetScannerStatus( Handle, &status );
if ( retcode != SUCCESS )
{
printf( ”\nERROR: OC_GetScannerStatus failed: %d\n”, retcode );
Ioexit( 1 );
}
if ( status != SCANSTS_INIT)
{
printf(”\nERROR: POST failure detected: %d\n”, status);
Ioexit(1);
}
/*
** Initialize the DPR partitions
** You can use OC_CreateIOConfiguration to determine the I/O image table
** sizes before paritioning the DPR
*/
ocpart.OutputImageSize = 0x800;
ocpart.InputImageSize = 0x800;
ocpart.HostRetentiveDataSize = 0;
retcode = OC_InitScanner( Handle, &ocpart );
if ( retcode != SUCCESS )
{
printf(” \nERROR: OC_InitScanner failed: %d\n”, retcode );
Ioexit( 1 );
}
/*
** Display software/hardware versions
*/
retcode = OC_GetVersionInfo( Handle, &verinfo );
if ( retcode != SUCCESS )
{
printf( ”\nERROR: OC_GetVersionInfo failed: %d\n”, retcode );
Ioexit( 1 );
}
printf( ”\n\n Scanner Firmware Series: %02d Revision: %02d ”,
verinfo.ScannerFirmwareSeries, verinfo.ScannerFirmwareRevision );
printf( ”\n Hardware Series: %02d Revision: %02d”,
verinfo.OCHardwareSeries, verinfo.OCHardwareRevision );
delay( 3000 );
Access the
scanner
See page 6-48.