Rockwell Automation 1608S I-Sense User Manual User Manual
Bulletin 1608s voltage sag detector
Table of contents
Document Outline
- Important User Information
- Table of Contents
- Quick Start and Introduction
- Getting Started
- 1. Inspect for shipping damage. If any damage is seen, contact the shipper.
- 2. Record the i-Sense Serial Number: ___________ - ___________ - ___________ The S/N label is located on the bottom of the unit; it will be needed to register/use this i-Sense.
- 3. Register the i-Sense (monitor subscription included with purchase, future renewals will be required to continue accessing data.):
- 4. Configure the i-Sense hardware to match your nominal voltage:
- 5. Configure the i-Sense software and communications according to the Configuration Chapter. This step may be performed either before or after installation. Needed supplies:
- 6. Install the i-Sense according to Installation on page 12
- 7. Electrical installation must be performed by a qualified electrician or technician in an appropriate environment (See Technical Specifications on page 19).
- 8. Perform step 5, if skipped earlier.
- 9. Verify communications: push the ♡ button to generate a Heartbeat event. Verify that the event is logged at www.igrid.com.
- Introduction
- Configuration
- Configure for your Nominal Voltage
- Configure Communications Settings
- Ethernet Communications Setup
- Installation
- Pre-installation
- 1. Inspect for shipping damage
- 2. Record the i-Sense serial number (See Getting Started on page 4
- 3. Register the i-Sense at www.igrid.com (See Getting Started on page 4)
- 4. Configure the i-Sense hardware for the service voltage (See Getting Started on page 4)
- 5. Configure communications software using the Ethernet port. (this can be done after installation and power-up)
- Environmental Conditions
- Mounting
- Electrical Connections
- Nominal Voltage Configurations
- Table 1 - Nominal Voltage Configurations. (shipped standard with 480V (L-L)
- 1. Select your voltage configuration from Table 1 and follow the instructions in the corresponding wiring diagram from Table 2.
- 2. Use the appropriate wiring diagram and jumper wire positions. The i-Sense is shipped with jumper wires in the LL configuration. The LL and LN diagrams are also shown inside the i-Sense cover. Move or remove jumper wires as needed.
- Communications Connections
- Final Check
- External Power Supply
- Initial Battery Charge Time
- Operation, Maintenance and Troubleshooting
- User controls and indicators
- Battery Replacement
- Technical Specifications
- Standards Compliance and Certifications
- Compliance Information
- FCC PART 68
- Industry Canada Notice
- FCC Part 15 Class A Digital Equipment
- CTR21 Statement