Rockwell Automation 1606-XLE480FP Power Supply Reference Manual - Manual (Page 16)

All parameters are specified at 48V, 10A, 230Vac, 25°C ambient and after a 5 minutes run-in time, unless noted otherwise.
16 Rockwell Automation Publication 1606-RM043A-EN-P — March 2014
Bulletin 1606 Switched Mode Power Supplies
18. Dielectric Strength
The output voltage is floating and has no ohmic connection to the ground. Type and factory tests are conducted by
the manufacturer. Field tests may be conducted in the field using the appropriate test equipment which applies the
voltage with a slow ramp (2s up and 2s down). Connect all input-terminals together as well as all output poles before
conducting the test. When testing, set the cut-off current settings to the value in the table below.
Fig. 18-1 Dielectric strength A B C D
Type test 60s 2500Vac 3000Vac 1000Vac 500Vac
Factory test 5s 2500Vac 2500Vac 500Vac 500Vac
Field test 5s 2000Vac 2000Vac 500Vac 500Vac
Cut-off current setting > 15mA > 15mA > 20mA > 1mA
D A
C
B
B *)
N
L
Input DC-ok
Earth, PE Output
-
+
To meet the PELV requirements according to EN60204-1 § 6.4.1, we
recommend that either the + pole, the – pole or any other part of
the output circuit be connected to the protective earth
system. This helps to avoid situations in which a load starts
unexpectedly or cannot be switched off when unnoticed ground
faults occur.
B*) When testing input to DC-OK ensure that the max. voltage between DC-OK and the output is not exceeded (column D). We recommend
connecting DC-OK pins and the output pins together when performing the test.
19. Certifications
EC Declaration of Conformity The CE Mark indicates conformance with the
- EMC directive 2004/108/EC,
- Low-voltage directive (LVD) 2006/95/EC and
UL 508
IND. CONT. EQ.
Listed E56639 for use in the U.S.A. (UL 508) and Canada
(C22.2 No. 60950)
Industrial Control Equipment
UL 60950-1 RECOGNIZED E56639 for use in the U.S.A. (UL 60950-1)
and Canada (C22.2 No. 60950-1)
Information Technology Equipment, Level 3
CSA C22.2 No.107.1,
ISA 12.12.01 CSA Certified under File Number 240020. CERTIFIED for use
in the U.S.A. (ISA 12.12.01) and Canada (C22.2 No. 213)
Hazardous Location Class I, Div. 2, Groups A, B, C, D
ATEX
II 3G Ex nA nC II T3 Gc
GOST R
GOST R certification is applicable for products for sale and use
within Russia. See below for link to the Certificate.
II 3G Ex nA nC II T3 Gc
C-Tick C-tick compliance is for products intended for sale and use within
the Australian market. See below for link to the C-tick Declarations
of Conformity.
Product certification information (including Certificates and Declarations of Conformity) can be found at www.ab.com/certification .