Rockwell Automation 1204-TFB2 Terminator - Manual (Page 7)

1204 Terminator (Class 1, Division 2) 7
Installation Installation of the 1204 Terminator must be in accordance with
Class I, Division 2 wiring methods as defined in Article 501-4(b) of
the National Electrical Code, NFPA 70 for installations within the
United States, or as specified in Section 18-152 of the Canadian
Electrical Code for installation within Canada.
To install the terminator, follow these steps:
1. Remove all power connected to the system.
2. Mount the terminator on a metal surface.
!
WARNING: EXPLOSION HAZARD
• Substitution of components may impair suitability for
Class I, Division 2.
• When in hazardous locations, turn off power before
replacing or wiring modules.
• Do not disconnect equipment unless power has been
switched off or the area is known to be nonhazardous.
!
ATTENTION: Electric shock can cause injury or
death. Remove all power before working with this
product. Verify that the voltage on the bus capacitors
has discharged. Measure the DC bus voltage at the +
and – terminals of TB1. The voltage must be zero.
ATTENTION: The terminator surfaces may be hot
enough to cause serious burns. You should take this into
consideration when deciding where to mount your
terminator.
Metal Surface
Air Flow
Front View Front View Front View
Top View Top View
Allen-Bradley Motor Terminator
DANGER
CAN CAUSE SHOCK, BURNS, OR DEATH DISCONNECT AND LOCKOUT ALL POWER SOURCES BEFORE SERVICING SURFACES MAY BE HOT ALLOW TO COOL BEFORE SERVICING
Bulletin 1204-TFB2 Series A AC Drive HP .5 to 600 Voltage 380-600 VAC Carrier Freq.
≤ 2 KHz
Made in U.S.A.
See Instruction Manual For Mounting Instructions Allen-Bradley
Motor Terminator
® Q E T N O C D N I X 6 6 9 D E T S I L
® Q E T N O C D N I X 6 6 9 D E T S I L
Important: Heatsink Fins Must be Vertical.
DANGER
CAN CAUSE SHOCK, BURNS, OR DEATH DISCONNECT AND LOCKOUT ALL POWER SOURCES BEFORE SERVICING
SURFACES MAY BE HOT ALLOW TO COOL BEFORE SERVICING
Assembled in Mexico
See Instruction Manual For Mounting Instructions
Bulletin 1204–TFXX Series A
AC Drive HP ZZZZ
Voltage WWWW VAC
Max. Carrier Freq. Y KHz
Type 4X Enclosure
Hazardous Locations
Class I, Division 2
Groups A, B, C, D
Temperature Code T3 (200˚ c)
UL ® C US LISTED IND. CONT. EQ. FOR USE IN HAZ. LOC. 8AA4