Rockwell Automation 1606-XLDC92D Power Supply Reference Manual - Manual (Page 4)

All parameters are specified at 24V, 3.8A, 24Vdc input voltage, 25°C ambient and after a 5 minutes run-in time, unless noted otherwise.
4 Rockwell Automation Publication 1606-RM023A-EN-P — January 2014
Bulletin 1606 Switched Mode Power Supplies
3. Input Voltage
Input voltage nom. DC 24V
Input voltage range 14.4-32.4Vdc full specified
max. 36.0Vdc absolute maximum continuous input voltage with no
damage to the DC/DC converter
Allowed voltage between input
and earth max. 60Vdc or
42.2Vac
in case the output voltage is not grounded.
Allowed input ripple voltage
max. 5Vpp 47Hz-40kHz, the momentary input voltage must always
be within the specified limits.
Turn-on voltage typ. 17.5Vdc steady-state value, see Fig. 3-1
Shut-down voltage typ. 14.0Vdc steady-state value, see Fig. 3-1
typ. 35.0Vdc steady-state value, see Fig. 3-1
Input current typ. 4.25A at 24Vdc input and output 24V, 3.8A, see Fig. 3-3
Start-up delay typ. 290ms see Fig. 3-2
Rise time typ. 520ms 0mF, 24V, resistive load 3.8A, see Fig. 3-2
typ. 610ms 3.8mF, 24V, resistive load 3.8A, see Fig. 3-2
Turn-on overshoot max. 500mV see Fig. 3-1
Input capacitance typ. 3 000μF external capacitors on the input voltage bus are allowed
without any limitations.
Fig. 3-1 Input voltage range
Tur
n
-on
17.
5V
dc
V
IN
P
OUT
S
hut
-down
4V
dc
0V
dc
4V
dc
32. 14. 14.
Rated input range
35.
0V
dc
Fig. 3-2 Turn-on behavior, definitions Fig. 3-3 Input current vs. output load
Start-up
delay
Rise
Time
Ov
4A
ersh
oot
- 5%
Output
Voltage
Input
Voltage
1 1.5 2 3
0
1
3
5
6A
Output Current
2.5 3.5 0.5
Input Current, typ
Inp
ut:
18
Vd
c
2
4
Inpu
t: 2
4Vd
c