Rockwell Automation 1492 1771-to-1756 I/O Swing-arm Conversion System - Manual (Page 11)

(11)
II. Conversion Steps
9) Attach the 1492 Cables with 1756 Swing-Arms to the Appropriate 1756 I/O Module
Use the following procedure:
a) Closely review the labels on the conversion modules and the 1492 cables to ensure they are the correct mates for the 1756 I/O module (Refer to
Appendix B).
b) Making sure you have the correct cable, slowly guide the terminal block end into the mating connector of the 1756 I/O module (Refer to Figure 9a).
c) Refer to Figure 9b. Firmly press the two components together and secure the terminal block to the 1756 I/O module.
10000060110 (Version 00)
Figure 9a
Figure 9b