Rockwell Automation 1502 Electrically-Held to Mechanically Latched Contactor - Retrofit Instructions - Manual (Page 9)

Electrically Held to Mechanical Latch Contactor • Retrofit Instructions 5
1502-IN001%-EN-P – -XQH
Install the Mechanically Latched Auxiliary Contact Assembly
1. Wire the closing and trip coils to the Mechanically Latched
auxiliary contact assembly as shown in the diagram below:
Figure 6 – Auxiliary Contact Assembly Layout
2. Slide the auxiliary contact assembly back into the contactor and
hand tighten the retaining bolt so the assembly remains in position.
3. Re-Install the auxiliary actuator plate on the main shaft assembly.
Figure 7 – Contactor (front angle view) after
Auxiliary Actuator Plate is re-assembled