Rockwell Automation 1502 Electrically-Held to Mechanically Latched Contactor - Retrofit Instructions - Manual (Page 12)

8 Electrically Held to Mechanical Latch Contactor • Retrofit Instructions
1502-IN001 %-EN-P – -XQH
Figure 10 – Contactor (rear view) showing wires to be wire-tied
Electrical
Test
1. Connect the contactor to the control using the supplied umbilical
cord.
2. Test the latch by electrically engaging the contactor using the
control circuit.
3. If the contactor fails to latch, re-calibrate the gaps between the
auxiliary contacts and contact actuator plate and the gap between
the latch roller and contactor armature plate.
Figure 11 – Complete Contactor after Conversion