Rockwell Automation 160IB1 InterBus Communication Module - Manual (Page 29)

Using the 160-IB1 on InterBus 6–3
Click (select) the controller board and right mouse click ”type” to
select the type of scanner.
Click IBS USC(4K) as the controller type and click ok.
With the ”controller board” selected, hit F3 on your PC (the state
button). Select Configuration (on-line) and click ok. If the processor
is faulted, you will not be able to go on-line. So put the processor into
program mode with the keyswitch., then select Configuration
(on-line).
Now select ”configuration” and ” configuration frame” and ”read in ”
the network that is attached to the scanner.
You will probably get the message that the parameterisation of the
controller board will be lost. This is ok because it was not valid
anyway. Select Yes.
Also you may get the message that the software is unable to read the
parameter channel settings. Select OK to continue.
In this case you see one module has been identified as a DRIVECOM
assembly with InterBus library identifier 227.