Rockwell Automation 160IB1 InterBus Communication Module - Manual (Page 19)

Chapter
4
Modes of Operation
Chapter 4 contains the following information:
• Powering up the drive with the IB1 Module installed.
• The modes of operation and LED indications.
Powering Up the Drive After you have installed the IB1 Module, apply power to the drive and
to the connected device. The READY LED should illuminate.
If it does not, refer to Chapter 8, Troubleshooting.
LED Indicators The IB1 Module has five LEDs (see figure below) which provide
module status.
The LEDs are defined as follows:
• Four Communication Status LEDs – These LEDs have the
following functions:
RC (yellow): Remote bus Check (Input cable connection o.k.)
BA (green): Bus Active
TR (green): Transmit/Receive (PCP Communication active)
RD (red): Remote bus Disable (Output cable connection
missing)
• FLT (red) – This LED tracks the fault status of the 160 Drive.
When no faults are present, the LED will be off. The LED will
illuminate (red) if a drive fault occurs.
For more information refer to Table 8.A.
RD LED
TR LED
FAULT LED
BA LED
RC LED