Rockwell Automation 160 160SSC CopyCat Keypad - Manual (Page 20)

2-8 How to Program the Drive
Possible Load TO Drive Errors
When the Enter key is pressed to begin a Load to Drive operation, an error message
is displayed if any of the following conditions exist.
The selected drive configuration file is empty or does not exist.
Press the Escape key or Enter key to return to the Load Menu.
Follow the steps beginning on page 3-6 to choose a different drive configuration file.
The drive configuration file and drive parameter sets do not match. Analog Signal
Follower and Preset Speed models are not compatible.
Press the Escape key or Enter key to return to the Load Menu.
Follow the steps beginning on page 3-6 to choose a different drive configuration file.
The drive is running or is locked.
Stop the drive or set P57 - [Program Lock] to 0 to unlock the drive.
A parameter value is either incompatible, out of range, or not recognized.
Do one of the following:
• Press the Enter key to accept the parameter value as shown and continue
loading.
• Enter a new parameter value and press Enter to continue loading.
• Press the Escape key, then
Press the Enter key to stop loading.