Rockwell Automation 825P Modular Protection System Quick Start Guide - Manual (Page 30)

Quick Start Guide — Allen-Bradley Bulletin 825-P Modular Protection System
30
Figure 19 Main Menu > Show/Set >
Relay Cont’d
Relay Cont’d
Steps back one
level
Undervoltage Set Load Control Set
UV TRIP LEVEL LOAD CONTROL SEL
UV TRIP DELAY LD CTL CUR UPPER
UV WARN LEVEL LD CTL CUR LOWER
UV WARN DELAY LD CTL PWR UPPER
Overvoltage Set LD CTL PWR LOWER
OV TRIP LEVEL LD CTL TCU UPPER
OV TRIP DELAY LC CTL TCU LOWER
OV WARN LEVEL I/O Settings
OV WARN DELAY ANALOG OG OUT SEL
VAR Setting Trip Inhibit
NEG VAR TRIP CURRENT INBALANC
POS BAR TRIP JAM
VAR TRIP DELAY GROUND FAULT
NEG VAR WARN LEV SHORT CIRCUIT
PAS VAR WARN LEV UNDERCURRENT
VAR WARN DELAY START INHIBIT
Underpower Set PTC
UP TRIP LEVEL RTD
UP TRIP DELAY Relay Behavior
UP WARN LEVEL TRIP FAIL-SAFE
UP WARN DELAY AUX1 FAIL-SAFE
Power Factor Set AUX2 FAIL-SAFE
PF LAG TRIP LEVEL AUX3 FAIL-SAFE
PF LD TRIP LEVEL AUX4 FAIL-SAFE
PF TRIP DELAY AUX5 FAIL-SAFE
PF LAG WARN LEVEL AUX6 FAIL-SAFE
PF LD WARN LEVEL Timer Settings
PF WARN DELAY ON DELAY T1
Freq Settings OFF DELAY T1
FREQ1 TRIP LEVEL ON DELAY T2
FREQ1 TRIP DELAY OFF DELAY T2
FREQ1 WARN LEVEL Front Panel Set
FREQ1 WARN DELAY LCD TIMEOUT
FREQ2 TRIP LEVEL LCD CONTRAST
FREQ2 TRIP DELAY Display Set
FREQ2 WARN LEVEL TIME & DATE
FREQ2 WARN DELAY GROUND CURRENT
Phase Rev Set CURRENT IMBALANC
PH REV. ENABLE FREQUENCY
THERM CAP USED
VOLTAGE IMBALANC
POWER
RTD TEMPERATURE