Environment and enclosure, Prevent electrostatic discharge – Rockwell Automation 56RF High Frequency 13.56 MHz RFID EtherNet/IP Interface Block User Manual
Page 3

High Frequency 13.56 MHz RFID EtherNet/IP Interface Block 3
Drawing Number
10000181820 Ver. 01 - November 2012
Environment and Enclosure
Follow these guidelines for environment and enclosure information for this
equipment.
Prevent Electrostatic Discharge
Follow these guidelines when you handle this equipment.
ATTENTION
This equipment is intended for use in overvoltage Category II applications (as
defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is considered Group 1, Class A industrial equipment according
to IEC/CISPR 11. Without appropriate precautions, there may be difficulties with
electromagnetic compatibility in residential and other environments due
to conducted and radiated disturbances.
This equipment is supplied as enclosed equipment. It should not require additional system
enclosure when used in locations consistent with the enclosure type ratings stated in the
Specifications section of this publication. Subsequent sections of this publication may
contain additional information regarding specific enclosure type ratings, beyond what this
product provides, that are required to comply with certain product safety certifications.
In addition to this publication, see:
• Industrial Automation Wiring and Grounding Guidelines, Rockwell Automation
publicat
• NEMA Standards 250 and IEC 60529, as applicable, for explanations of the degrees of
protection provided by different types of enclosure.
ATTENTION
This equipment is sensitive to electrostatic discharge that can cause internal damage and
affect normal operation. Follow these guidelines when you handle this equipment.
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wrist strap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• Use a static-safe workstation if available.
• Store the equipment in appropriate static-safe packaging when not in use.