Rockwell Automation 1336S_E Drive Multipulse Bridge Assembly - Manual (Page 8)

8 Multipulse Bridge Assembly Parts Kits
Converter Thermal Switch
Replacement Kit Where This Kit Is Used
Converter Thermal Switch Replacement (Catalog Number
1336-TR-SP8A) - You can use this kit to replace the thermal switch(es) that
are located on the multipulse bridge assembly in the converter bay of your
1336 PLUS II Multipulse or H-Frame IMPACT drive.
Table 5. Thermal Switch Part Numbers
What This Kit Contains
This kit contains a replacement thermal switch and these instructions.
Locating the Thermal Switches
The thermal switches are mounted on the bridge heatsink located in the
converter bay of your drive.
Important: On some drive models the thermal switch may be located
remotely at the top of the heatsink above the bus bars as shown in the
following illustration. In cases where the thermal switch is mounted
remotely it will not be necessary to remove the “AK” input terminals or bus
bars for access to the switch.
Replacement Kit # Vendor #
1336 - TR- SP8A 16283
Fan
Remote
Thermal
Switch(es)
Location
Internal Mount
Thermal
Switch(es)
Location