Rockwell Automation 20P PowerFlex DC Drive - Frame B Pulse Transformer Circuit Board - Manual

Publication 20P-IN009D-EN-P - February
Installation Instructions
PowerFlex DC Drive Frame B Pulse Transformer Circuit Board
What This Kit Includes
• Pulse Transformer circuit board
• Terminal block with 1k ohm resistor @ terminals 78 & 79
• Seven screws and washers for board
• 6 gate lead cables with connectors (for non-regenerative drives only)
• 12 gate lead cables with connectors (for regenerative drives only)
• 4 cables for connectors X3, X4, XP and XR
• Static strap
Tools That You Need • Phillips ®
screwdriver
• Flathead screwdriver
• Nut driver or wrench for hex stand-offs
• Multimeter (capable of reading to a thousandth of an Ohm)
• Wire cutter
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC drives and associated
machinery should plan or implement the installation, start-up and subsequent
maintenance of the system. Failure to comply may result in personal injury and/
or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all power to the drive
has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts
and assemblies. Static control precautions are required when installing, testing,
servicing or repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with static control
procedures, reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection handbook.