BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 80)

Rev. 3.02 - 80 -
SRP-270
8-8-2-3 Base Paper Feed Assy - #3
Name of Parts Method and Procedure
① SUB PCB ASSY
② SCREW TAPPING (M2*3, 2EA)
③ MANUAL CUTTER
④ SCREW (M3*6, 2EA)
⑤ PLATEN PAPER GUIDE
⑥ SHAFT HOLE ROLLER
⑦ HOLE ROLLER (2EA)
⑧ SPRING HOLD ROLLER (2EA)
1. Set SUB PCB ASSY to fit the hole in the bottom face of ①
BASE PAPER FEED and tighten two SCREW TAPPING. ②
2. Set the MANUAL CUTTER to the boss on the BASE ③
PAPER FEED and tighten two SCREW. ④
3. Hook PLATEN PAPER GUIDE on the manual cutter in the ⑤
front face of BASE PAPER FEED.
4. Grease section of SHAFT HOLE ROLLER mounted HOLE ⑥
ROLLER and insert two HOLE ROLLER ⑦ . Next, set SHAFT
to the each groove of BASE PAPER FEED as fitting HOLD
ROLLER into PPG.
5. Hook two SPRING HOLD ROLLER ⑧ on the both side of
BASE PAPER FEED.
Check the location of PLATEN PAPER GUIDE, status of
hooking, coming off.