BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 78)

Rev. 3.02 - 78 -
SRP-270
8-8-2 Main-assemblies
8-8-2-1 Base Paper Feed Assy - #1
Name of Parts Method and Procedure
① BASE PAPER FEED
② SHAFT TAKE UP
③ TAPE CUSION
④ RUBBER PLATE (2EA)
⑤ PLATEN ASSY
⑥ SCREW SPECIAL (M2.6*7.5, 2EA)
⑦ SHAFT RUBBER ROLLER
⑧ ROLLER PAPER GUIDE (2EA)
⑨ BEARING (2EA)
⑩ E-RING (ø3, 2EA)
⑪ GEAR ROLLER
⑫ BRACKET PF R ASSY
⑬ STEP MOTOR PF
⑭ SCREW TAPPING (M3*6, 2EA)
1. At first, set BASE PAPER FEED in the JIG. Next, insert ①
SHAFT TAKE UP into the hole. ② Lastly, press it by Lever
Press.
2. Set TAPE CUSION to fit rectangular hole of BASE ③ ①
PAPER FEED and then, insert RUBBER PLATE in both ④
side.
3. Insert PLATEN ASSY into the rectangular hole and then, ⑤
tighten two SCREW SPECIAL. ⑥
4. Make BASE PAPER FEED st ① and(right side), and then,
insert two ROLLER PAPER GUIDE and BEARING to fit ⑧ ⑨
SHAFT RUBBER ROLLER in both side one by one. Next, ⑦
fix the Sub Assy into the back face of BASE PAPER FEED
①
and fit two E ⑩ -RING into the groove each other.
5. Set GEAR ROLLER on ⑪ to right side shaft of BASE ①
PAPER FEED and then set BRACKET PF R ASSY. ⑫
6. Insert STEP MOTOR PF into the rectangular hole of ⑬
BRACKET PF and drag backward. Next, tighten two
SCREW TAPPING on BRACKET PF R ASSY. ⑭ ⑫
Check ROLLER to rotate smoothly.