BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 43)

Rev. 3.02 - 43 -
SRP-270
5-8 Printer Assy (SRP-270D Type)
1. Before you disassembly the Printer Assy, you
should remove :
- Plate Bottom (see Chapter 4-2)
- Cover Assy (see Chapter 4-3 & 4-4)
- Case Upper Assy (see Chapter 4-6)
2. Remove the Spool Gear and Belt, as shown
below.(SRP-270D Type)
3. Remove two screws securing the Printer Assy.
Separate the Printer Assy from the Case Lower.
5-9 Auto Cutter Assy
1. Before you disassembly the Auto Cutter Assy, you
should remove :
- Plate Bottom (see Chapter 4-2)
- Cover Assy (see Chapter 4-3 & 4-4)
- Case Upper Assy (see Chapter 4-6)
- Printer Assy (see Chapter 4-7 & 4-8)
2. Remove two screws securing the Auto Cutter
Assy. Separate the Auto Cutter Assy from the
Printer Assy, as shown below.
3. Before you reassembly the Auto Cutter Assy,
you should set up the Belt and Hinge.