BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 76)

Rev. 3.02 - 76 -
SRP-270
8-8-1-4 Lever Tension Belt C Assy
Name of Parts Method and Procedure Drawings
SHAFT PUL ① LEY
LEVER TENSION ②
BELT
PULLEY
③
WASHER ④
(2.6*5.0*0.5)
1. At first, grease SHAFT PULLEY ①
with HG-31S.
2. Next insert PULLEY and then ③
assemble WASHER (2.6*5.0*0.5). ④
Check PULLEY to rotate smoothly.
③
8-8-1-5 Sub PCB Assy
Name of Parts Method and Procedure Drawings
SUB PCB ①
SWITCH LEVER ②
WIRE ASSY ③
1. Insert SWITCH LEVER to fit the ②
hole of SUB PCB. ①
2. And then, solder the land on the
SUB PCB bottom side and attach ①
the WIRE ASSY on the land A, G.
③
After soldering, check the frozen lead
and short.
8-8-1-6 Cover Head Assy
Name of Parts Method and Procedure Drawings
COVER HEAD ①
SCREW MANUAL ②
E ③ -RING (ø2.5)
CAUTION LABEL ④
1. Insert the SCREW MANUAL into ②
the right side hole of COVER ①
HEAD.
2. And then, assemble E ③ -RING onto
the starting point of a spiral during
adhering closely to the COVER
①
HEAD.
3. Paste the CAUTION LABEL on ④
the right bottom side.