Wolo 440 Godfather - Manual (Page 2)

ELECTRICAL CONNECTIONS FOR A NEW HORN BUTTON SWITCH:
Install the relay in a dry location with the terminals facing downward near the compressor. Refer to Figure D for wiring.
A. Connect relay terminal 87 to
the positive terminal at the
bottom of the compressor.
Use no less than a 16-
gauge wire.
B. Connect relay terminal 85 to
the horn switch terminal.
The other horn switch
terminal is connected to
ground (body of vehicle). An
18-gauge wire is suggested
for this connection.
C. Connect relay terminals
30/86 to positive (+) 12-volt
battery, alternator or
accessories. Use 16-gauge
or heavier wire. A 20-
ampere fuse is suggested
to be installed as shown in
Figure D.
RECAP OF TERMINAL CONNECTIONS
Terminals 30/86: the two (2) terminals are connected to 12-volt positive (+) using a fuse.
Terminal 85: connect horn switch negative (-).
Terminal 87: connect positive (+) terminal of compressor.
Warranty
Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase,
that this product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will
either repair or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase
together with proof of purchase as described below. Wolo reserves the right to inspect any defect prior to settling any
warranty claim by repair or replacement. This warranty is limited as above provided and Wolo will not be responsible for
fire or other casualty or accident, due to neglect, abuse, abnormal use, modifications, faulty installation of this product, or
natural causes.
ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF
THREE (3) MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON
FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY OR
OTHERWISE.
To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase. Provide
with the return a brief description of the problem. Also, include with the return a check or money order in the amount of $10.00 to
cover return shipping. Mail to:
Wolo Manufacturing Corp. One Saxwood Street, Deer Park, NY 11729
Attn: Warranty Service E-mail: [email protected]
© 2006 Wolo Mfg. Corp
All Rights Reserved.
ELECTRICAL CONNECTIONS USING VEHICLE’S
FACTORY HORN SWITCH
For a vehicle with a (2) wire system: If vehicle’s factory horn has two (2) terminals, simply transfer the wires to the
terminals on the bottom of the compressor.
IMPORTANT: when testing the horns, if compressor motor turns on but
the horn does not sound, reverse the wires connected at the bottom of the compressor.
For a vehicle with a (1) wire system: If vehicle’s factory horn has one (1) terminal, simply transfer wire to the
compressor’s positive (+) terminal on bottom of compressor. The compressor’s negative terminal is connected to
any metal body ground. Connection should be free of rust or paint.