Wolo 120 Persuader - Manual

INSTALLATION INSTRUCTIONS
Model 120 PERSUADER XTREME
Your choice of a Wolo horn is a perfect choice to compliment your vessel or vehicle. Wolo horn’s are manufactured with the
finest quality materials and every horn is inspected and tested before being packaged. Precision workmanship and quality
components will assure years of dependable service. If you need help installing your new Wolo horn, or have any questions,
our technicians are available to answer your questions, Monday through Friday from 9 AM to 4 PM EST at
1-888-550-HORN (4676)
MOUNTING
1. Locate the desired area you wish to mount the Persuader Horn. For best results, the front of the horn should be
unobstructed so that the horn’s sound can project straight ahead. Use the horn’s gasket as a template, mark hole
locations and drill to size. (See Fig. A.)
2. Mark the wire hole location if the horn’s wire is going to pass through the mounting surface and drill to size. (See Fig. C)
IMPORTANT: Make sure the hole is free of any burrs that could cut into the horn’s wire. For roof mount mounting, to
prevent water leaks, it is recommended that silicon or a waterproof sealer be placed on the wire at the point of entry
into the roof.
3. Secure the horn using the
hardware provided. Tighten
screws evenly to prevent damage
to the horn. (See Fig. A.)
IMPORTANT: Be sure to use the
rubber gasket to protect against
water leaks.
4. Push the front bracket forward
until it is tight. Use the bracket as
a template, mark hole location and
drill to size. (See Fig. B).
5. Secure the front trumpet bracket
to the location using the hardware
provided. Tighten screws evenly.
IMPORTANT: Be sure to use the
rubber gasket to protect against
water leaks.
3/16 ”
3/16 ”
3/16 ”
3/16 ”