Wolo 410 Wobbler User Manual

Page 2

ELECTRICAL CONNECTIONS FOR A NEW HORN BUTTON SWITCH: FIG. D

Install the relay in a dry location with the terminals facing downward near the compressor.

A. Connect relay terminal 87 to

the positive terminal at the
bottom of the compressor.
Use no less than a 16-gauge
wire.

B. Connect relay terminal 85 to

the horn switch terminal. The
other horn switch terminal is
connected to ground (body of
vehicle). An 18-gauge wire is
suggested for this connection.

C. Connect relay terminals 30/86

to positive (+) 12-volt battery,
alternator or accessories. Use
16-gauge or heavier wire. A
20-ampere fuse is suggested
to be installed as shown in
Figure D.

RECAP OF TERMINAL CONNECTIONS

Terminals 30/86: the two (2) terminals are connected to 12-volt positive (+) using a fuse.
Terminal 85: connect horn switch negative (-).
Terminal 87: connect positive (+) terminal of compressor.

TOGGLE SWITCH INSTALLATION FIG. E

The toggle switch, included in kit, will control the horn’s sounds.
One position for a steady three trumpet sound and the other
will produce a alternating sound.

5. Mount the toggle switch in an accessible location

inside the vehicle.

6. Connect one terminal of the toggle switch to ground, any body bolt in

the dashboard area. Make sure the surface is clean from dirt and rust
so as to make a good electrical connection.

7. Connect the other terminal of the toggle switch to the compressor’s

minus (-) terminal on the side of the compressor using the black wire
with the insulated terminal provided.

8. Attach the red wire with the insulated terminal to the compressor’s

positive (+) terminal on the side of the compressor. Splice the other end of the wire to the wire that is connected on
the bottom of the compressor’s motor marked positive (+), as shown. IMPORTANT: The (+) terminal on the side
must be connected only as shown in Fig. E to prevent damage to the compressor.

Warranty

Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase,
that this product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will
either repair or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase
together with proof of purchase as described below. Wolo reserves the right to inspect any defect prior to settling any
warranty claim by repair or replacement. This warranty is limited as above provided and Wolo will not be responsible for
fire or other casualty or accident, due to neglect, abuse, abnormal use, modifications, faulty installation of this product, or
natural causes.

ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF
THREE (3) MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON
FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY OR
OTHERWISE.

To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase. Provide
with the return a brief description of the problem. Also, include with the return a check or money order in the amount of $10.00 to
cover return shipping. Mail to:

Wolo Manufacturing Corp. One Saxwood Street, Deer Park, NY 11729
Attn: Warranty Service E-mail: [email protected]

(not included)