Warranty – Wolo 810 Challenger User Manual
Page 2

WIRING COMPRESSOR (Fig . F)
16. The compressor’s red wire is connected to (+) 12-
volt power source using the fuse provided.
IMPORTANT! The red wire must be connected to a
(+) 12-volt power source only when the vehicle
ignition is turned on. This will protect your
compressor from running continuously and being
damaged if an air leak develops when the vehicle is
not in operation. Suggested connection points are:
blower motor, windshield wiper motor or accessory
terminal on the fuse panel. Make sure the
connection point has a wire that is as heavy as the
compressor wire.
OPTIONAL: A switch can be installed into the
compressor’s red wire. This will permit the driver to turn-off the system if it is not required.
17. Remove the plastic cap covering the pressure switch on the side of the tank. The compressor’s black wire is connected to one of
the terminals of the pressure switch.
18. Connect the short black length of wire provided to the other terminal of the pressure switch.
19. The other end of the black wire is connected to ground; secure the wire’s terminal to either the (-) side of vehicles battery or
under any metal body bolt. Make sure that ground connection is free of rust and paint.
NOTE: The compressor is now ready to be used and will automatically start when the air pressure drops in the tank. The built-in
regulator will automatically turn off the compressor when the tank‘s air pressure is approximately 110 p.s.i. If the compressor does not
shut off after 4 minutes of running time, check all air hose connections for leaks. Use soapy water or bubble solution on each fitting
while the compressor is pumping. Use a thread sealant if leak persists after tightening.
CAUTION: Do not touch compressor or fittings with bare hands during or immediately after usage, they will be hot.
WARRANTY
Wolo Manufacturing Corporation (“Wolo”) warranties to the original purchaser, for three months from the date of purchase, that
this product is free from defects in workmanship and materials. If there is such a proven defect, Wolo, at its option, will either repair
or replace the item free of charge, if it is returned to Wolo within three months from the date of purchase together with proof of
purchase as described below. Wolo reserves the right to inspect any defect prior to settling any warranty claim by repair or
replacement. This warranty is limited as above provided and Wolo will not be responsible for fire or other casualty or accident, due
to neglect, abuse, abnormal use, modifications, faulty installation of this product, or natural causes.
ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM
OF THREE (3) MONTHS. UNDER NO CIRCUMSTANCES SHALL WOLO BE LIABLE TO PURCHASER OR ANY OTHER PERSON
FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY OR OTHERWISE.
To obtain warranty service, return the product prepaid, and include the original bill of sale showing the date of purchase. Provide with
the return a brief description of the problem. Also, include with the return a check or money order in the amount of $10.00 to cover
return shipping. Mail to:
Wolo Manufacturing Corp.
One Saxwood Street, Deer Park, NY 11729
Attn: Warranty Service
E-mail: [email protected]
© 2006 Wolo Mfg. Corp All Rights Reserved.